|
08-29-2010, 01:01 AM
|
#61 |
|
Senior Member
Join Date: Feb 2009
Location: anacrime
Posts: 326
|
 taking the car to the shop  took off the trans  motor is next to come out  put on my throttle body  polished it by hand  started to work on the bay 
__________________
 stock camaro z28 
|
|
|
|
09-01-2010, 12:01 AM
|
#62 |
|
Senior Member
Join Date: Feb 2009
Location: anacrime
Posts: 326
|
hit the bay again and more then half way done. after that im going to spray it with black paint
__________________
stock camaro z28
|
|
|
|
|
09-01-2010, 01:36 AM
|
#63 | |
|
Senior Member
Join Date: May 2009
Location: Longbeach
Posts: 462
 |
Quote:
Make sure to do a primer before the black. -Mike
__________________
 1991 chevy camaro RS, LS1 SWAP, LS1 rear end, gas tank, fuel lines, radiator dual fans, aluminum drive shaft, black ZR1, cross drilled rotors, KYB ADJ shocks, lower brace bar (RED), clear side markers, HID projectors 12000k, Z28 spoiler, Z28/Iroc front grill inserts with foglights, racing seats, 4 point harness  2007 Trailblazer ss 6.0 LS2, Corsa h-pipe, spintech exhaust dumps, cross drilled rotors. |
|
|
|
|
|
09-01-2010, 11:51 AM
|
#64 |
|
General Joser
Join Date: Feb 2009
Location: Home of the Angels!
Posts: 90,640
|
thats tight man!!!
__________________
01 Camaro SS #4488 
|
|
|
|
|
09-01-2010, 02:48 PM
|
#65 |
|
Senior Member
Join Date: Feb 2009
Location: anacrime
Posts: 326
|
i use the billet polished made by mother but i hit the throttle body wit 2000 grit sandpaper firt and wet sanded it. after that i polished it
__________________
stock camaro z28
|
|
|
|
|
09-01-2010, 02:48 PM
|
#66 | |
|
Senior Member
Join Date: Feb 2009
Location: anacrime
Posts: 326
|
Quote:
__________________
stock camaro z28
|
|
|
|
|
|
09-01-2010, 10:13 PM
|
#67 | |
|
Senior Member
Join Date: May 2009
Location: Longbeach
Posts: 462
|
Quote:
Do you even have wipers? if not take that wiper motor out. -Mike
__________________
1991 chevy camaro RS, LS1 SWAP, LS1 rear end, gas tank, fuel lines, radiator dual fans, aluminum drive shaft, black ZR1, cross drilled rotors, KYB ADJ shocks, lower brace bar (RED), clear side markers, HID projectors 12000k, Z28 spoiler, Z28/Iroc front grill inserts with foglights, racing seats, 4 point harness 2007 Trailblazer ss 6.0 LS2, Corsa h-pipe, spintech exhaust dumps, cross drilled rotors. |
|
|
|
|
|
09-02-2010, 12:43 AM
|
#68 |
|
Senior Member
Join Date: Feb 2009
Location: anacrime
Posts: 326
|
i did already the other day i was there
__________________
stock camaro z28
|
|
|
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
